Non Slip Bullnose Stair Nosing Rubber Angle Step Edge Trim

 FEATURES & Benefits

•  High quality profile for use on stairs and communication runs
•  Protects the edges against mechanical damage
•  Protects against slipping and falling - the corrugated part of the slat ensures safe use of the stairs
•  Easy to clean - special shape of grooves
•  Increased number of grooves compared to other products on the market
•  Does not contain harmful compounds for humans and animals
•  Highly flexible product - "shape memory" Easy assembly (No maintenance required)
•  Installation on the lined stairs with carpeting, tile, panel or other finishing material of any thickness
•  Made of a special PVC mixture

The PVC stair nosing or bull nosing is the perfect hard wearing safety measure for indoor steps. High quality profile for use on stairs and communication runs  Installation on the lined stairs with carpeting, tile, panel or other finishing material of any thickness

Installation should be at room temperature - clean and align the surface of the stairs -cut to the exact step width using knife -apply assembly glue or double-sided tape ! do not glue the lower part to the step ! -press firmly -allow the glue to dry

Stair Tread Protector comes very well packaged so that it could not be bent or twisted in any way. Each trim comes pristine in manufacturer packaging supplied with correct screws and plugs for installation.

The PVC stair nosing or bull nosing is the perfect hard wearing safety measure for indoor steps.
They prevent your feet from slipping and protects the stair corners from damage and can be adhered with a contact adhesive.

Installation:
InstallationShould take place at room temperature. In case of low temperatures, the profile should be heated before installation using warm air or water
Clean and even out the surface of the stairs
Cut the profile to the exact step width using knife or shears
Apply assembly glue according to glue manufacturer's instructions or use glue tape by sticking it ONLY on the whole surface of the upper part of the profile (do not glue the lower part to the step)
Press firmly to the step and allow the glue to dry